manual   quickstart   instguide   update   basis

Next: 38.1.5 Printing options Up: 38.1 The property program Previous: 38.1.3 Orbital analysis (ORBITAL)   Contents   Index   PDF

38.1.4 Specification of one-electron operators

The required operators are specified by code words. Optionally, the geometry or the nuclear centre at which the operator is computed can be specified.

For each operator, an input card of the following form is required:


code specifies the property. The available operators are given in section 6.13.

The other parameters have the following meaning:

row number of Z-matrix or atomic symbol defining the centre at which property shall be calculated; if centre$\ne 0$ you need not read in coordinates.
cartesian coordinates of the point (only if centre=0).
the operator is multiplied by this factor. The default is factor=1 except for REL. In this cases proper factors for relativistic corrections are used unless factor is given. The two commas before factor are needed to preserve compatibility with Molpro96. 2018-02-24