<div dir="ltr"><div><div><div><div><div><div>Dear Molpro users,<br><br></div>I have noticed something that may be a bug in Molpro 2015.1.<br></div>Sometimes when performing CC calculations on extreme geometries, the CC iterations run into trouble, and Molpro prints "UNREASONABLE NORM. CALCULATION STOPPED".</div><div><br></div>This would be completely fine, however Molpro then proceeds to carry on with the obviously doomed calculation until either the maximum number of iterations are reached, or the calculation implodes into NaNs(yes, that does happen), thus wasting CPU time, that could be saved by just aborting immediately. (see attached log)<br></div><br></div>I think, since the message states it is stopping, but it keeps going, this is a bug. What are your thoughts?<br><br></div>Tibor Győri<br>MSc student<br>University of Szeged</div>