65.1 Calling the matrix facility (MATROP)

The program is called by the input card MATROP without further specifications.


It can be followed by the following commands in any order, with the restriction that a maximum of 50 matrices can be handled. The first entry in each command line is a command keyword, followed by the name of the result matrix. If the specified result matrix result already exists, it is overwritten, otherwise a new matrix is created. All matrices needed in the operations must must have been loaded or defined before, unless otherwise stated.

If a backquote (`) is appended to a name, the matrix is transposed.

molpro@molpro.net 2019-07-16